Barcode Scanner Troubleshooting

If the keyboard refuses to pop up when you’re in the app it means the Socket Mobile is in HID mode. Use the manual and scan the control barcode to switch to iOS mode. Or scan the below barcode from an iPad or Retina screen. You may be unable to scan from other screens. The scanner will beep 3 times when a scan is successful.

If you are unable to connect the scanner to ShipHero and have already reviewed the Socket Mobile Manual, you can try following these steps.

  1. On your scanner, press the “scan” then “power” button on the scanner and hold them down simultaneously for a few seconds, until the scanner shuts down with 3 beeps.
  2. Go to Bluetooth on the iPad, and “forget” the scanner.
  3. Turn off Bluetooth on the iPad.
  4. Turn the scanner back on, and try scanning the below Factory Reset Barcode. You should hear several tones and the scanner will turn off
  5. Turn the scanner back on, and then scan the below iOS Mode Barcode. You should hear 3 beeps only. Please Note: If you hear 3 beeps followed by a long tone, the long tone indicates an error. This means the device can not enter the correct mode. You will need to contact Socket Mobile Support to resolve the issue.
  6. If you only hear 3 beeps after scanning the iOS Mode Barcode, try turning Bluetooth back on the iPad.
  7. Connect the scanner to Bluetooth.

Factory Reset Barcode

iOS Mode Barcode

Tip: The Socket Mobile Command Sheet

Note: iOS 11 added another layer of Bluetooth control. After turning on Bluetooth in the settings menu, you will also need to tap "Allow New Connections" if the prompt appears. If you open the Control Center, verify that the Bluetooth button is also turned on.
If you have already upgraded to iOS 11, please make sure you are using at least Version 11.1. Earlier versions of iOS 11 are not compatible with the Socket Mobile Scanners in iOS mode.